Sometimes clear clingy stamps aren't so clingy.
(The actually red rubber stamps that have clear plastic on top
to 'cling' to the stamping block--not the photopolymear clear
Often times I put a bit of moisture on the top of the stamp
before I attach it to the block. This forms a suction that will hold it in place.
I have also read that a bit of two way glue, or two sided
tape helps to hold it to the block as well.
I have not tried this yet, so I'm not sure whether to put
the adhesive on the block or the stamp.
It would probably be easier to clean the sticky off of the block.
Share if you have other ways to keep the stamps
from slip-sliding away.